I have here 2 off taper shank drills on a no3 morse taper.
59/64” diameter x 10. 1/2” inches long over all. Made by Alfin and is high speed steel. The first 1/2 inch could do with being ground off as it looks a bit worn, but will still be of good use once reground at the tip. The flutes further up are good and the drill runs true. The price reflects the work that needs to be done.
As a bonus I also have with it 24.5mm diameter drill x 10.1/2” long over all. Made by Intal, good condition and runs true. Only asking £8.00 for both.
Buyer to collect from Coventry CV5, or I can post at buyers expense.
59/64” diameter x 10. 1/2” inches long over all. Made by Alfin and is high speed steel. The first 1/2 inch could do with being ground off as it looks a bit worn, but will still be of good use once reground at the tip. The flutes further up are good and the drill runs true. The price reflects the work that needs to be done.
As a bonus I also have with it 24.5mm diameter drill x 10.1/2” long over all. Made by Intal, good condition and runs true. Only asking £8.00 for both.
Buyer to collect from Coventry CV5, or I can post at buyers expense.
I have here 2 off taper shank drills on a no3 morse taper.
59/64” diameter x 10. 1/2” inches long over all. Made by Alfin and is high speed steel. The first 1/2 inch could do with being ground off as it looks a bit worn, but will still be of good use once reground at the tip. The flutes further up are good and the drill runs true. The price reflects the work that needs to be done.
As a bonus I also have with it 24.5mm diameter drill x 10.1/2” long over all. Made by Intal, good condition and runs true. Only asking £8.00 for both.
Buyer to collect from Coventry CV5, or I can post at buyers expense.
0 Comments
0 Shares
0 Reviews
